High-Output Infrared Lamps for Semiconductor Fabrication
Need a direct replacement for your fab equipment? We’ve got you covered. Our inventory is stacked with IR lamps that step right in, matching the heat output and reliability of the originals. These aren’t your average heaters. They’re built for the tough, non-negotiable demands of semiconductor processing—where rock-solid temperature control and lightning-fast response are the only way to play.
Specs That Actually Matter: Power, Voltage, Size
Let’s get into the details that make the difference. Our 400V, 2500W setup packs serious power into a small footprint. It’s designed to plug straight into the standard power setup of high-end fab gear, so you don’t have to rewire anything. And the 300mm tube length? That’s a standard size. It slips right into existing fixtures without messing with the machine’s layout. Installation stays quick, and downtime stays minimal.
Built to Last: Halogen, Coating, and Connectors
Inside, the lamp runs on a halogen-filled quartz envelope. That keeps output steady over time. The halogen cycle keeps the filament clean, which means longer life and far less drift. A special coating on the quartz focuses the energy into shortwave IR. That gives you fast, efficient heat transfer. The R7s connector is a proven bi-pin design that holds tight, even when things get hot and cold over and over. It stays secure through repeated thermal cycles—no wiggle, no loose connections.
What It Does in the Fab: Heat, Fast and Repeatable
On the line, these lamps shine in rapid thermal processes, annealing, and wafer heating. You get fast ramp-up and tight temperature control, thanks to high power density and shortwave IR. The payoff? Consistent cycles and repeatable results. A heads-up: 2500W puts out a lot of heat. Make sure your equipment’s cooling and thermal shielding are up to the job. And because downtime is the enemy, we keep a big inventory on hand. When a lamp burns out, you can swap it in immediately and keep the line moving.